AEI Security & Communications DGHDP1 Manual de Instruções descarregar pdf (Página 20)

Page 20 Please read the instructions carefully prior to installation

DGHDP1 - DigiSender® HD Pro - Single Input Powerline AV Sender System

(EN) ENGLISH

Advanced Procedures

Resetting the System Settings to Factory Defaults

The following procedure will revert the DigiSender® HD Pro system settings back to factory default and should

only be used during troubleshooting.

1. Reset the Transmitter System Settings to Factory Defaults:

At the Transmitter, press the Group Button on the DigiSender® remote control CONTINUOUSLY (in

rapid succession) until both the Power LED goes OFF and the Sync LED comes ON and then press

the OK Button on the DigiSender® remote control.

The Power and Sync LEDs will ﬂash OFF-ON-OFF-ON and then the Transmitter will reboot itself.

The Transmitter system settings have now been set back to the factory defaults.

2. Reset the Receiver System Settings to Factory Defaults:

At the Receiver, press the Group Button on the DigiSender® remote control AT LEAST 5 TIMES (in

rapid succession) until the receiving TV displays the message “Conﬁrm - Reset System Settings to

Factory Defaults?”. Then press and hold the Group Button on the back of the Receiver for

approximately 6 seconds.

The receiving TV will display the message “System Settings Reset to Factory Defaults” and then

the screen will go blank and the TV will display the message “Not Synced - Please perform Syncing

Operation”.

The Receiver system settings have now been set back to the factory defaults.

Note: After completing the Resetting the System Settings to Factory Defaults procedure you will need to com-

plete the Transmitter & Receiver Syncing procedure on page 18.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 111 112

Sem comentários

AEI Security & Communications DGHDP1 Manual de Instruções Página 20