AEI Security & Communications DGHDP1 Manual de Instruções descarregar pdf (Página 21)

Page 21Please read the instructions carefully prior to installation

DGHDP1 - DigiSender® HD Pro - Single Input Powerline AV Sender System

ENGLISH (EN)

Advanced Procedures

Resetting the PLC Settings to Factory Defaults

The following procedure will revert the DigiSender® HD Pro PLC settings back to factory default and should only

be used during troubleshooting.

1. Reset the Transmitter PLC Settings to Factory Defaults:

At the Transmitter, press the Factory Button on the DigiSender® remote control CONTINUOUSLY (in

rapid succession) until the Power LED and the Sync LED goes OFF, and then press the

OK Button on the DigiSender® remote control.

The Power and Sync LEDs will ﬂash OFF-ON-OFF-ON and then the Transmitter will reboot itself.

The Transmitter PLC settings have now been set back to the factory defaults.

2. Reset the Receiver PLC Settings to Factory Defaults:

At the Receiver, press the Factory Button on the DigiSender® remote control, in rapid succession,

until the receiving TV displays the message “Conﬁrm - Reset PLC Settings to Factory Defaults?”

and then press the OK Button on the DigiSender® remote control (you can press any other button on

the DigiSender® remote control to cancel the operation.

The Receiver PLC settings have now been set back to the factory defaults.

Note: After completing the Resetting the PLC Settings to Factory Defaults procedure you will need to complete

the PLC Grouping procedure on page 19.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 111 112

Sem comentários

AEI Security & Communications DGHDP1 Manual de Instruções Página 21